SI-TEX 12CI Pumpset – 12VDC

Description

The SI-TEX 12CI Pumpset provides reversible hydraulic flow for small to medium steering rams with an 18-cubic-inch system capacity. Its 12V DC permanent-magnet motor delivers 0.8 to 1.0 liters per minute at a listed 50-bar pressure, while SP-70, SP-80, SP-110, NAC-2, and NAC-3 compatibility supports the connected autopilot computers. The pump uses 1/4-inch NPT fittings and vertical or horizontal foot mounting.

Typical cruising draw ranges from 3 to 7 amps, with a maximum load of 15 amps. Mounting hardware and a sealing kit are included, while the anodized aluminum and steel-alloy housing carries IP55 protection.

Key Specifications of the SI-TEX 12CI Hydraulic Pumpset

• Reversible gear pump supports hydraulic autopilot systems.
• System capacity is rated at 12 cubic inches.
• Flow rate ranges from 0.8 to 1.0 liters per minute.
• Maximum pressure is listed at 50 bar.
• 12V DC operation is specified.
• Typical cruising draw ranges from 3 to 7 amps.
• Maximum current draw reaches 15 amps.
• SP-70, SP-80, SP-110, NAC-2, and NAC-3 compatibility is listed.
• One-quarter-inch NPT fittings provide hydraulic connections.
• Mounting hardware and sealing kit are included.

Pump Function, Flow, and Controls

The SI-TEX pump provides dual-direction hydraulic flow at the listed 0.8 to 1.0-liter-per-minute rate. Its permanent-magnet DC motor supports reversing operation, while self-priming height, dry-run capability, duty cycle, and thermal protection are not specified.

Plumbing, Power, and Compatibility Considerations

Verify the 12-cubic-inch capacity, 50-bar pressure, 12V supply, 3 to 7-amp typical draw, 15-amp maximum load, controller compatibility, NPT fittings, hydraulic lines, and power wiring before installation.

Mounting, Installation, and Environmental Conditions

Confirm the 205mm chassis length, 95mm body diameter, vertical or horizontal foot mounting, hydraulic-line access, cable routing, service clearance, operating temperature, and IP55 rating before installation.

Warranty and Support

Warranty coverage is not confirmed in the available product data. Buyers should verify current coverage, exclusions, and claim procedures with the seller or manufacturer before purchase. These terms reflect currently available manufacturer information, and buyers should verify active warranty policies directly with the seller or manufacturer before purchase.

Before Ordering the SI-TEX 12CI Hydraulic Pumpset

Verify the 12-cubic-inch capacity, 0.8 to 1.0-liter flow, 50-bar pressure, 12V supply, current demand, controller compatibility, NPT fittings, mounting position, sealing kit, and package contents before ordering.