FLIR M300C – Single Payload HD Marine Camera (No JCU)

Description

Inspect distant shoreline details and vessel activity in daylight or low-light conditions with the FLIR M300C Visible-Light Marine Camera. Its 30× optical zoom, 1080p sensor, and two-axis gyro stabilization give operators a controlled visual view without adding a thermal imaging payload. Need a pan-and-tilt camera that can frame a dock, buoy, shoreline, or approaching vessel from the helm? The M300C provides H.264 IP, HD-SDI, and analog video options, plus continuous 360° pan and a 64° to 2.3° optical field of view.

Key Specifications

• FLIR M300C single-payload HD visible-light marine camera, supplied without a JCU controller.
• 2.1-megapixel 1920 × 1080 Full HD visible camera.
• 30× optical zoom and 12× digital zoom.
• Optical field of view from approximately 64° wide to 2.3° telephoto.
• Ultra-low-light sensitivity rated at approximately 0.0008 lux in high-sensitivity mode.
• Two-axis integrated gyro stabilization.
• Continuous 360° pan and ±90° tilt.
• H.264 IP, HD-SDI, and analog-video output options.
• Supports compatible NMEA 2000 and ONVIF integration.
• 12V/24V DC or PoE+ power arrangements with up to approximately 41W maximum draw.
• IP67 housing, approximately 8.7 × 12.9 inches, and approximately 13.9 lb (6.3 kg).

Integration

The M300C needs a compatible MFD, monitor, NVR, or IP-video viewer. This version does not include a JCU, so verify whether the camera will be controlled from a compatible MFD or through a separately purchased FLIR controller. Confirm the required IP, HD-SDI, or analog video path along with network bandwidth, ONVIF support, and power requirements.

The camera relies on available ambient light and cannot see through complete darkness like a thermal camera. Low-light results vary with moonlight, shore lighting, glare, haze, rain, spray, target contrast, range, lens condition, zoom level, and camera placement. It is an additional observation aid—not a replacement for radar, navigation lights, charts, lookout responsibilities, or safe operating procedures.

Installation Notes

Mount the M300C on a rigid location with clear sightlines and complete pan-and-tilt clearance. Avoid exhaust, strong deck-light glare, antennas, rails, rigging, radar-transmission zones, and structures that can obstruct movement or reduce image quality. Plan the power, Ethernet, HD-SDI, analog-video, and NMEA cable routes before installation.

Use correctly sized wiring, approved circuit protection, sealed marine cable entries, and corrosion-resistant mounting hardware. Have a qualified marine-electronics installer configure video output, IP settings, camera control, and display integration.

Before Ordering

Confirm MFD/monitor compatibility, preferred video output, camera-control method, NMEA/ONVIF integration, PoE+ or 12V/24V power capacity, mount strength, full sweep clearance, cable routes, and whether visible low-light video rather than thermal imaging meets the intended needs before ordering.