March Pumps TE-7P-MD – 3180 GPH – 115V-230v – 1Ph

Description

Circulate marine air-conditioning water, compatible chemicals, or industrial liquids with the March Pumps TE-7P-MD 1-Phase Magnetic Drive Centrifugal Pump. This seal-less centrifugal pump is intended for a flooded-suction installation and has a maximum rated flow of 3,180 GPH (53 GPM / 200.6 LPM), maximum head of 53 ft, and a listed maximum pressure of 23 PSI.

The March Pumps TE-7P-MD one-phase model has a glass-filled polypropylene housing and impeller, ceramic magnet and shaft, and Viton O-ring. It uses a 1 HP continuous-duty motor operating at 115V or 230V single-phase AC, with a 1-1/2-inch FPT inlet and 1-inch MPT outlet.

Key Features

• Seal-less magnetic-drive centrifugal configuration for the listed leak-resistant liquid-circulation application.
• Maximum rated flow of 3,180 GPH, 53 GPM, or 200.6 LPM.
• Maximum rated head of 53 ft (16.1 m) and maximum pressure of 23 PSI.
• Flooded-suction, non-self-priming operation requires a continuously supplied inlet.
• 115V or 230V single-phase AC operation.
• 1 HP (0.74 kW) continuous-duty motor.
• Listed full-load current of 11.2A at 115V or 5.6A at 230V.
• Glass-filled polypropylene housing and impeller with ceramic magnetic components.
• Ceramic shaft and Viton O-ring for the listed seal-less design.
• 1-1/2-inch FPT inlet and 1-inch MPT outlet.

Compatibility and Installation

The TE-7P-MD one-phase model is specified for marine AC cooling, chemical circulation, and industrial liquid transfer. It is non-self-priming and needs a flooded-suction installation; do not rely on it to lift liquid from a dry inlet line. Confirm that the fluid is compatible with the polypropylene, ceramic, and Viton wetted components, and that the electrical system provides the correct 115V or 230V single-phase AC configuration.

Flow at the discharge point will be lower than the maximum rating when the system has elevation, restrictive plumbing, long pipe runs, fittings, or other resistance. the listed liquid-temperature limit is 190 degrees F (87 degrees C). Follow the pump manufacturer’s instructions and use qualified electrical and marine-plumbing practices for mounting, circuit protection, wiring, inlet support, discharge routing, and leak testing.

Before Ordering

Verify the March Pumps TE-7P-MD one-phase model, 115V or 230V single-phase AC requirement, 1 HP motor, full-load current, 3,180 GPH maximum flow, 53 ft maximum head, 23 PSI maximum pressure, flooded-suction requirement, 1-1/2-inch FPT inlet, 1-inch MPT outlet, polypropylene body and impeller, ceramic shaft and magnet, Viton O-ring, 190 degrees F maximum liquid temperature, 416 x 205 x 221 mm dimensions, 32 lb dry weight, and 1-year limited manufacturer warranty before purchase.