March Pumps TE-7P-MD – 3180 GPH / 53 GPH – 115V-230v – 3 Ph

Description

Circulate marine HVAC water, chiller fluid, or compatible chemicals with the March Pumps TE-7P-MD 3-Phase Magnetic Drive Centrifugal Pump. This seal-less centrifugal pump is designed for flooded-suction installations and provides a maximum rated flow of 3,180 GPH (53 GPM / 200.6 LPM), up to 53 ft of head, and a listed maximum pressure of 23 PSI.

March Pumps model TE-7P-MD 0155-0010-0100 uses a glass-filled polypropylene housing and impeller, ceramic magnet and shaft, plus a Viton O-ring. It operates on 115V or 230V three-phase AC power with a 1 HP continuous-duty motor. The pump has a 1-1/2-inch FPT inlet and 1-inch MPT outlet.

Key Features

• Seal-less magnetic-drive centrifugal design eliminates a conventional dynamic shaft seal.
• Maximum rated flow of 3,180 GPH, 53 GPM, or 200.6 LPM.
• Maximum rated head of 53 ft (16.1 m) and maximum pressure of 23 PSI.
• Flooded-suction, non-self-priming design requires a continuously flooded inlet arrangement.
• 115V or 230V three-phase AC operation for compatible onboard or shore-powered systems.
• 1 HP (0.74 kW) continuous-duty motor.
• Listed current draw of 5.6A at 115V or 2.8A at 230V.
• Glass-filled polypropylene wetted body and impeller with ceramic magnetic components.
• Ceramic shaft and Viton O-ring for the listed seal-less leak-resistant design.
• 1-1/2-inch FPT inlet and 1-inch MPT outlet.

Compatibility and Installation

This pump is specified for marine HVAC circulation, chemical transfer, and liquid-chiller systems. It is not self-priming: install it with flooded suction and configure the inlet plumbing so the pump receives liquid continuously before operation. The 3-phase electrical supply, 115V or 230V voltage selection, flow requirements, fluid compatibility, and 1-1/2-inch FPT by 1-inch MPT plumbing must all match the vessel or facility system.

Maximum flow is a pump-curve rating, not a guaranteed installed flow. Actual output varies with total dynamic head, suction conditions, discharge piping, fittings, temperature, fluid properties, and electrical supply. The maximum specified liquid temperature is 190 degrees F (87 degrees C). Follow March Pumps documentation and qualified marine or electrical installation practices for mounting, circuit protection, wiring, bonding, plumbing, and commissioning.

Before Ordering

Verify March Pumps model TE-7P-MD 0155-0010-0100, three-phase configuration, 115V or 230V AC power, 1 HP continuous-duty motor, 3,180 GPH maximum flow, 53 ft maximum head, 23 PSI maximum pressure, flooded-suction requirement, 1-1/2-inch FPT inlet, 1-inch MPT outlet, polypropylene and ceramic wetted components, Viton O-ring, 190 degrees F maximum liquid temperature, 416 x 205 x 221 mm dimensions, 32 lb dry weight, listed UL recognition and CSA component status, and 1-year limited manufacturer warranty before purchase.