FLIR JCU-1 Joystick Control Unit f/M-Series – RJ45 Connection

Description

Take direct control of a compatible FLIR M-Series pan-and-tilt camera with the FLIR JCU-1 Joystick Control Unit. Its backlit keypad, joystick, and dedicated camera controls give the helm a tactile alternative to relying only on touchscreen commands when adjusting pan, tilt, zoom, tracking, and camera modes in low light or rough conditions. Need a physical controller for an existing FLIR thermal or visible camera system? The JCU-1 connects through a wired RJ45 network connection and mounts at the dash or another protected control location.

Key Specifications

• FLIR JCU-1 Joystick Control Unit for compatible FLIR M-Series cameras, part number 432-0045-00.
• Dedicated wired camera controller with joystick and backlit rubber keypad.
• Supports pan, tilt, zoom, camera mode, and compatible tracking-control functions.
• RJ45 Ethernet connection; not a wireless controller.
• Can be powered through the network or an appropriate external 12V/24V DC supply, depending on system configuration.
• Power consumption is less than 3W.
• IPX6 weather protection for supported flush or surface mounting.
• Operating temperature range of -13°F to 131°F (-25°C to 55°C).
• Approximate dimensions: 5.3 × 3.4 × 3.2 inches; approximate weight: 1.0 lb (0.45 kg).

Integration

The JCU-1 is a controller, not a camera, display, video recorder, chartplotter, or thermal sensor. It requires a compatible FLIR M-Series camera and appropriate Ethernet network configuration. It can supplement compatible MFD control, but it does not replace the display or video connection required to view camera output.

FLIR M-Series product information identifies the JCU-1 and PoE injector as included components for applicable M300-series packages. [853] Confirm the specific camera model, firmware, network topology, and available control ports because compatibility can vary across older and newer FLIR M-Series generations.

Installation Notes

Mount the JCU-1 at a protected helm location where the joystick and buttons are reachable without interfering with vessel operation. Use a secure RJ45 connection, protected cable routing, and appropriate sealing for exposed installations. Keep the controller away from standing water, heavy spray, direct heat, and locations that could obstruct safe helm access.

Follow FLIR instructions for network setup, addressing, power method, and camera pairing. A qualified installer should configure control functions and test response from the helm before regular use.

Before Ordering

Confirm the exact FLIR M-Series camera model, JCU-1 compatibility, required Ethernet connection, PoE or external-power method, dashboard cutout or bracket location, cable length, and desired control arrangement before ordering.