FLIR MD-324 Static Thermal Marine Navigation Camera

Description

Improve fixed-direction thermal awareness on a compact marine installation with the FLIR MD-324 Static Thermal Navigation Camera. Its 320 × 240 VOx thermal core, 24° horizontal field of view, and 19 mm lens give boaters a practical way to observe heat contrast ahead of the vessel, along a dock, or around a fixed boarding area in darkness or reduced visibility. Need thermal video without the size and moving parts of a pan-and-tilt turret? The MD-324 supports H.264/MJPEG IP streaming, analog video output, and PoE or 12V DC power in a weatherproof fixed-mount housing.

Key Specifications

• FLIR MD-324 fixed-mount thermal marine camera, part number 432-0003-24-00S.
• 320 × 240 uncooled VOx microbolometer thermal core.
• 19 mm fixed lens with a 24° horizontal and 18° vertical field of view.
• 2× digital zoom support.
• Long-wave infrared thermal imaging operating across the 7.5–13.5 µm band.
• H.264/MJPEG IP video streaming through a web interface.
• Analog video output through F-Type connection or compatible BNC adapter.
• 12V DC or IEEE 802.3af Power over Ethernet operation.
• Approximately 1.0A typical 12V draw and up to 3.0A during heater cycles.
• IPX6/IPX7 weather protection and approximately 3.0 lb (1.36 kg) weight.

Integration

The MD-324 requires a compatible MFD, monitor, NVR, or IP-video viewer. It is not a chartplotter, radar, GPS receiver, NMEA 2000 device, or standalone recording system. Confirm whether the installation will use H.264/MJPEG Ethernet video or analog output, along with display compatibility, PoE availability, and required adapters.

Thermal imaging detects heat contrast rather than guaranteeing object identification. Weather, humidity, rain, sea spray, water and air temperature, target size, range, lens condition, and installation height affect practical visibility. Use it as an additional awareness tool alongside radar, charts, navigation lights, sound signals, proper watchkeeping, and safe speed.

Installation Notes

Mount the fixed camera on a rigid deck, hardtop, mast, or bulkhead location with a clear view in the intended direction. Since it does not pan or tilt, check its 24° horizontal framing before drilling. Keep the lens clear of rails, antennas, rigging, lights, exhaust, and structures that can obstruct the thermal image.

Use sealed IP or analog-video connections, a properly protected 12V circuit or suitable PoE source, and marine-grade mounting hardware. Routinely inspect the lens, housing, mounting tabs, cable seals, and connectors after saltwater exposure.

Before Ordering

Confirm monitor or MFD video compatibility, desired IP versus analog output, PoE or 12V power method, 24° field-of-view suitability, fixed mounting position, cable route, and needed F-Type/BNC or Ethernet accessories before ordering.