IRIS A118 – Compact Analogue Hi-Def PTZ Marine Camera

Description

Control a broad-to-narrow visible camera view from a compact analog PTZ system with the IRIS A118 Marine Camera. Its 10× optical zoom, 360° continuous pan, built-in infrared illumination, and selectable AHD/TVI/CVI/CVBS formats provide a flexible option for boats using analog video monitors or DVRs. Need a low-light camera that can inspect both the dockside area and distant shoreline detail? The A118 combines 1080p analog HD output, digital stabilization, and Pelco-D RS485 control in an IP66-rated white marine housing.

Key Specifications

• IRIS A118 compact analog HD PTZ marine camera.
• 1080p video through selectable AHD, TVI, CVI, or CVBS analog formats.
• 10× optical zoom.
• Horizontal field of view from approximately 94° wide to 4.7° telephoto.
• Continuous 360° pan and -30° to +90° tilt range.
• Digital image stabilization.
• Built-in infrared illumination with up to approximately 164 ft (50 m) of viewing range under suitable conditions.
• RS485 serial control using Pelco-D protocol.
• 12V DC input with up to approximately 15W maximum power draw.
• IP66 anodized-aluminum housing with white powder-coated finish and approximately 4.2 lb (1.9 kg) weight.

Integration

The A118 requires a compatible analog HD monitor, DVR, MFD video input, or video interface, plus an RS485 controller for PTZ functions. It is not an Ethernet IP camera, ONVIF device, NMEA 2000 camera, chartplotter, radar, or GPS receiver. Confirm the receiving equipment supports the selected AHD, TVI, CVI, or CVBS format before installation.

The published approximate human observation distance of 820 ft is a conditional estimate, not a guaranteed detection or identification range. Low-light and IR performance depend on weather, rain, fog, spray, target reflectivity, lighting, zoom level, lens cleanliness, and mounting location.

Installation Notes

Mount the camera on a rigid deck, hardtop, mast, or arch location with full pan-and-tilt clearance. Keep it clear of radar transmission zones, rigging, antennas, rails, exhaust, lights, and structures that can block the camera view or movement. Plan BNC video, RS485 control, and 12V wiring before mounting.

Use sealed cable entries, marine-grade hardware, protected wire routing, and a correctly fused 12V circuit. A qualified installer should configure the video format, Pelco-D address, baud rate, PTZ presets, and controller response.

Before Ordering

Confirm display/DVR support for the selected analog format, RS485/Pelco-D control requirements, 12V power capacity, IR viewing needs, full PTZ clearance, mounting location, cable route, and desired optical zoom range before ordering.