Iris Hybrid Camera Recorder w/IrisControl f/Garmin OneHelm Host – 1TB HDD – 8 Analogue & 4 IP Camera Inputs

Description

Bring mixed analog and IP camera recording into a compatible Garmin helm with the Iris Hybrid Camera Recorder featuring IrisControl for Garmin OneHelm. Its 1TB hard drive, eight analog inputs, four IP camera inputs, and OneHelm integration give boat owners a practical way to centralize video from the cockpit, transom, engine room, boarding areas, and deck cameras. Need to retain existing analog cameras while adding IP models later? The IRIS-DVR-HYB-OH-8-4-1TB combines hybrid recording, up-to-4K monitor output, and Garmin Marine Network connectivity in a protected interior enclosure.

Key Specifications

• Iris Innovations Hybrid Camera Recorder with IrisControl for Garmin OneHelm, model IRIS-DVR-HYB-OH-8-4-1TB.
• Hybrid marine DVR/NVR with 1TB built-in hard-drive storage.
• Supports up to 8 analog BNC camera inputs and 4 IP camera inputs.
• Built-in IrisControl software for compatible Garmin OneHelm MFD integration.
• Up to 4K Ultra HD local display output through HDMI or VGA.
• Garmin Marine Network Ethernet, HDMI, VGA, USB, 8 BNC analog inputs, and 4 IP camera inputs.
• 12V/24V DC input with up to approximately 30W maximum power consumption.
• IP30 enclosure for dry, protected interior installation only.
• Operating range of 14°F to 122°F (-10°C to 50°C).
• Approximate dimensions: 11.8 × 8.7 × 2.6 inches; approximate weight: 4.8 lb (2.2 kg).

Integration

This recorder requires compatible analog and/or IP cameras, an appropriately designed Ethernet network, and a compatible Garmin MFD with the required OneHelm support. It does not include cameras, a Garmin chartplotter, a PoE switch, or guaranteed video-storage duration.

Retention time on the 1TB drive depends on the number of active cameras, analog/IP resolutions, frame rates, codec settings, bitrates, motion-recording rules, and overwrite policy. Confirm camera protocols, ONVIF support where applicable, network bandwidth, and Garmin software compatibility before purchase.

Installation Notes

Install the recorder in a dry, ventilated helm cabinet, equipment rack, or protected bulkhead location. Keep it away from direct spray, bilge moisture, engine heat, and excessive vibration. Allow room for cooling, cable service, HDD access, HDMI/VGA monitor connections, and labeled analog and Ethernet camera wiring.

Use correctly fused 12V/24V wiring, protected cable routes, and managed network switching where appropriate. A qualified installer should configure camera discovery, IP addressing, OneHelm integration, recording schedules, user access, and storage overwrite rules.

Before Ordering

Confirm Garmin MFD and OneHelm compatibility, analog/IP camera count, camera protocols, available network bandwidth, PoE requirements, 1TB retention expectations, monitor-output needs, protected mounting space, and 12V/24V power availability before ordering.