Simrad HALO 200X Radar Pedestal Only – 50W

Description

Build a flexible Simrad open-array radar system around the HALO 200X Pedestal, a 50W solid-state pulse-compression base for vessels that need radar performance without the cost or power level of the HALO 3000 platform. The pedestal can be matched with a 3-foot, 4-foot, or 6-foot HALO array, allowing owners to choose between compact installation dimensions and more precise bearing separation. Looking for Doppler-aware radar with fast refresh capability? The HALO 200X supports VelocityTrack, Bird Mode+, dual-range operation, and up to 72 NM of instrumented range when used with the required RI-50 interface and compatible Simrad electronics.

Key Specifications

• Simrad HALO 200X standard radar pedestal only, part number 000-15102-001.
• 50W solid-state pulse-compression radar pedestal.
• Requires a separately purchased compatible HALO 3-foot, 4-foot, or 6-foot open-array antenna.
• Up to 72 NM instrumented range in a complete compatible HALO 2000 configuration.
• Supports VelocityTrack Doppler, Bird Mode+, dual-range operation, and compatible target-tracking features.
• Rotation speeds from 16 to 48 RPM depending on operating mode.
• Requires the separately purchased Simrad RI-50 radar interface module.
• Uses vessel power through the RI-50: 12V systems require 10.8V–15V DC and 24V systems require 20V–31.2V DC at the interface input.
• IPX6 protection, approximately 44.8 lb (20.3 kg) pedestal weight, and 80-knot wind rating for the complete system.

Integration

This pedestal cannot operate independently. Complete the system with a compatible HALO antenna, RI-50 interface module, interconnection cable, Ethernet connection, compatible Simrad MFD, protected power circuit, and suitable mount. The RI-50 creates the nominal 50V DC pedestal supply and carries the radar Ethernet connection.

Array selection determines the beamwidth and sweep diameter. Simrad lists the HALO 2000 platform with 50W output, up to 72 NM range, and compatibility with 3-foot, 4-foot, and 6-foot arrays. [799][801]

Installation Notes

Install the pedestal on a strong, level platform with complete rotation clearance for the chosen array. Keep the scanner away from people, masts, antennas, rigging, lights, exhaust, and structures that can create shadowing. Install the RI-50 indoors in a protected and accessible location.

Use the recommended power protection and cable sizes, route radar wiring away from heat, water, abrasion, and high-current cables, then perform network setup and bearing alignment through the compatible Simrad display. Radar is a navigation aid and does not replace visual lookout, safe speed, charts, or collision-regulation compliance.

Before Ordering

Confirm the chosen 3-foot, 4-foot, or 6-foot HALO array, RI-50 interface, Simrad MFD compatibility, Ethernet network arrangement, 12V/24V electrical capacity, mounting strength, rotation clearance, cable lengths, and heading/GPS sensor requirements before ordering.