Garmin GC 245 Surface Mount Camera – Black

Description

Add a low-profile rear-view or monitoring camera to a dark-colored boat with the Garmin GC 245 Surface Mount Camera in Black. Its 105° horizontal field of view, reverse-image capability, and 720p video give captains a practical view of the transom, swim platform, cockpit, engine-space entrance, or docking side from a compatible Garmin display. Need a compact camera that supports either network video or analog composite video? The black GC 245 operates from 9V–32V DC and uses an IPX7-rated housing for exterior surface or bulkhead mounting.

Key Specifications

• Garmin GC 245 Surface Mount Camera, Black, part number 010-02570-00.
• 1280 × 720 HD video output.
• High-sensitivity low-light image sensor.
• 105° horizontal field of view.
• Supports reverse-image display configuration.
• Garmin Marine Network Ethernet and composite-video output options.
• 9V–32V DC input with up to approximately 2.5W power consumption.
• IPX7 water protection and operating range of 5°F to 131°F (-15°C to 55°C).
• Approximate dimensions: 2.2 × 2.8 inches; approximate weight: 0.44 lb (0.2 kg).
• Surface deck or bulkhead mounting configuration.

Integration

The GC 245 requires a compatible Garmin MFD, monitor, or video interface. Confirm whether the installation will use Garmin Marine Network video or composite output, and verify required adapters, available network ports, display support, and cable lengths before ordering.

This is a fixed camera and not a radar, chartplotter, GPS receiver, recording system, or autonomous docking device. Reverse-image support can make a stern-facing view more intuitive, but image quality depends on lighting, glare, rain, spray, lens condition, and the selected mounting angle.

Installation Notes

Mount the camera where it provides a clear view of the desired area, then test framing and reverse-image settings before drilling. Avoid positions exposed to exhaust, heavy spray, direct deck-light glare, rails, fishing gear, or other obstructions. Route power and video/network cables through protected paths with sealed entries and proper strain relief.

Use a correctly fused 9V–32V DC circuit and marine-grade mounting hardware. Inspect the lens, housing, seals, and cable connections regularly, and rinse salt deposits with fresh water when appropriate.

Before Ordering

Confirm Garmin MFD compatibility, desired Ethernet or composite-video output, 9V–32V power availability, black-housing preference, intended camera direction, mounting location, and required cables or adapters before ordering.