Octopus Type S Straight Shaft f/Mounting Behind the Dash f/Mechanical Drive Systems – Includes 90° Bezel Kit

Description

The Octopus Type S Straight Shaft Mechanical Drive with 90° Bezel Kit is a compact behind-dash mechanical autopilot drive for compatible standard push-pull steering cables. Its straight-shaft design is suited to helm consoles where an angled or tilt steering shaft is not required. The package includes a 90-degree bezel kit and mounting hardware for the stated flush-mount mechanical-drive configuration.

The 12V reversing gear motor delivers up to 150 lb of cable thrust, typically draws 3A to 5A, and can reach 12A under maximum load. It requires about 210 mm of behind-dash depth and weighs 3.9 kg, or 8.6 lb. This component is a steering drive only and requires a compatible autopilot computer, heading sensor, control interface, power system, and correctly installed mechanical steering cable.

Key Specifications

• Behind-dash mechanical rotary drive with a straight steering-shaft interface.
• Designed for compatible standard push-pull mechanical steering cables.
• Includes a 90-degree bezel kit and mounting hardware.
• Provides up to 150 lb of maximum cable thrust.
• Uses a 12V reversing gear motor for bidirectional mechanical cable movement.
• Typical power draw is 3A to 5A, with 12A maximum current under load.
• Requires approximately 210 mm of behind-dash drive depth.
• Weighs approximately 3.9 kg and uses a reinforced steel and industrial ABS housing for protected interior installation.

Installation Considerations

Confirm that the existing helm uses a compatible straight shaft and standard push-pull steering cable. The 90-degree bezel kit affects helm-panel orientation and should be evaluated against dashboard angle, steering-wheel position, available panel space, cable exit direction, and service clearance.

This is not a universal electrical replacement for all autopilot brands without verification. Match the drive to an approved control computer and confirm voltage, current capacity, motor-direction control, clutch operation where applicable, feedback arrangement, and required interface hardware. Keep the unit in a protected interior space consistent with its splash-protected housing description.

Before Ordering

Confirm a compatible straight-shaft mechanical helm, standard push-pull steering cable, 210 mm behind-dash depth, required 90-degree bezel orientation, matching autopilot processor, 12V supply, 12A circuit capacity, dashboard structural support, cable bend radius, full manual steering operation, and complete autopilot-system components before purchase.