Iris Control f/Garmin OneHelm Host Interface (No Recording) / IP Cameras

Description

Bring compatible IP camera controls into a Garmin OneHelm helm without adding onboard recording hardware using the Iris Control Gateway for Garmin OneHelm. This compact interface connects supported IP cameras to a compatible Garmin MFD, providing a centralized camera-control path while leaving recording to an optional separate NVR. Need PTZ and camera management on the chartplotter but do not need a built-in hard drive? The IRIS-OH-IP-NR supports wired Ethernet integration for protected interior installations.

Key Specifications

• Iris Innovations Control for Garmin OneHelm Host Interface, Non-Recording IP Camera Gateway, model IRIS-OH-IP-NR.
• Supports compatible IP camera integration with Garmin OneHelm MFD systems.
• Non-recording interface; no internal hard drive or camera-video recording capability.
• Uses wired Garmin Marine Network/Ethernet and IP camera connections.
• Requires a compatible Garmin MFD and separately purchased compatible IP cameras.
• 12V/24V DC input with up to approximately 15W maximum power consumption.
• IP30 enclosure for dry, protected interior installation only.
• Operating range of 14°F to 122°F (-10°C to 50°C).
• Approximate dimensions: 7.9 × 5.9 × 1.8 inches; approximate weight: 2.6 lb (1.2 kg).
• Supports desktop or bulkhead mounting.

Integration

This gateway is not a camera, MFD, NVR, PoE switch, GPS receiver, or radar. It needs compatible IP cameras, a supported Garmin OneHelm MFD, an appropriately designed Ethernet network, and any required PoE power source for the connected cameras. It provides camera integration and control but does not store video.

Confirm each camera’s ONVIF or manufacturer-specific compatibility, video codec, IP address, network bandwidth, and PTZ-control requirements. If recorded video is needed, select a separate compatible Iris recorder or NVR rather than this non-recording gateway.

Installation Notes

Install the gateway in a dry, ventilated, accessible helm cabinet or equipment compartment. Keep it away from direct spray, bilge moisture, heat, and high-vibration areas. Use correctly protected 12V/24V wiring and leave room for network cables, configuration access, and service.

Document all IP addresses, label camera cables, and test camera discovery, live video, and PTZ commands before completing the installation. Use a qualified installer for network design, OneHelm configuration, and security settings.

Before Ordering

Confirm Garmin MFD and OneHelm compatibility, camera count and protocol support, network-switch and PoE requirements, 12V/24V power, dry mounting space, cable routing, and whether non-recording operation meets the vessel’s monitoring needs.