Iris High Definition 3MP IP Mini Dome Camera – 2MP Resolution – 316 SS & 120-Degree HFOV – 2.8mm Lens

Description

Keep wide-angle coverage over a cockpit, boarding area, engine-room entrance, or cabin passage with the Iris High-Definition Marine IP Mini Dome Camera. Its 120° horizontal field of view and compact 316 stainless-steel housing give installers a low-profile camera option where a bullet camera may be too exposed or too directional. Need broad fixed coverage through a compatible IP camera network? The IRIS-DOME-3MP-28 provides 1080p output, ONVIF compatibility, and PoE support in an IP68-rated mini dome.

Key Specifications

• Iris Innovations High-Definition Marine IP Mini Dome Camera, model IRIS-DOME-3MP-28.
• 2MP Full HD 1920 × 1080 video output from a 3MP image-sensor platform.
• Fixed 2.8 mm lens with a 120° horizontal field of view.
• Wired Ethernet IP video through RJ45 with ONVIF compatibility.
• Supports 12V DC power and Power over Ethernet.
• IP68 marine-grade 316 stainless-steel enclosure.
• Up to approximately 5W maximum power consumption.
• Operating temperature range of -13°F to 131°F (-25°C to 55°C).
• Approximate dimensions: 3.5 × 2.6 inches; approximate weight: 1.3 lb (0.6 kg).
• Surface bulkhead or ceiling mounting options.

Integration

The mini dome needs a compatible MFD, monitor, NVR, or network-video viewer that supports its IP/ONVIF video stream. It is not a chartplotter, radar, GPS unit, recorder, or wireless camera. Verify camera discovery, supported video codec, network bandwidth, and PoE requirements before integrating it with an existing system.

The 120° wide-angle lens is useful for broad coverage but can make distant objects appear smaller. This fixed camera does not pan, tilt, or zoom, and image quality depends on lighting, lens cleanliness, moisture, glare, network conditions, and the selected installation location.

Installation Notes

Mount the dome where its wide field of view can cover the intended area without being blocked by rails, seating, rigging, lights, or equipment. Check the camera angle before drilling and avoid direct exhaust, intense lighting, or heavy spray positions that can affect the image.

Use sealed RJ45 and power connections, appropriate strain relief, corrosion-resistant hardware, and protected cable routing. If using PoE, confirm the switch or injector provides adequate power for all connected cameras. Inspect the lens, seals, and mounting hardware regularly.

Before Ordering

Confirm MFD/NVR ONVIF compatibility, available Ethernet and PoE capacity, desired 120° coverage area, surface or ceiling mounting location, cable route, and required waterproof network accessories before ordering.