Iris High Definition 3MP IP Mini Dome Camera – 2MP Resolution – 316 SS & 80-Degree HFOV – 3.6mm Lens

Description

Focus a more defined area of the boat with the Iris High Definition 3MP IP Mini Dome Camera with a 3.6 mm lens. Its 80° horizontal field of view provides a tighter image than an ultra-wide dome, making it useful for monitoring a boarding gate, cockpit entrance, transom, engine-room access, or a specific deck passage. Need a compact IP camera built for saltwater exposure? The IRIS-DOME-3MP-36 combines 1080p video, ONVIF-compatible Ethernet, PoE support, and a 316 stainless-steel IP68 housing.

Key Specifications

• Iris Innovations HD 3MP IP Mini Dome Camera with 3.6 mm Lens, model IRIS-DOME-3MP-36.
• 1920 × 1080 Full HD output from a 3MP sensor platform.
• Fixed 3.6 mm lens with an 80° horizontal field of view.
• Wired Ethernet IP video through RJ45 with ONVIF compatibility.
• Supports 12V DC power and Power over Ethernet.
• IP68 marine-grade 316 stainless-steel enclosure.
• Up to approximately 5W maximum power consumption.
• Operating range of -13°F to 131°F (-25°C to 55°C).
• Approximate dimensions: 3.5 × 2.6 inches; approximate weight: 1.3 lb (0.6 kg).
• Suitable for surface bulkhead or ceiling mounting.

Integration

This camera requires a compatible MFD, monitor, NVR, or IP-video viewer that supports Ethernet video and ONVIF camera discovery. It does not include a display, recorder, GPS receiver, radar, wireless connection, or PoE switch. Confirm camera protocol support, network bandwidth, PoE capacity, and desired recording setup before purchase.

The fixed 80° field of view provides more focused coverage than a 120° dome, but it does not pan, tilt, or optically zoom. Image quality depends on lighting, rain, spray, lens condition, camera placement, network conditions, and display settings.

Installation Notes

Mount the camera where its fixed view covers the intended area without being blocked by rails, doors, seating, rigging, lights, or deck equipment. Test framing before drilling and avoid exhaust, high-glare lights, and spray-heavy locations. Route Ethernet and power cables through protected, sealed paths away from heat, chafe, standing water, and high-current wiring.

Use marine-grade hardware and appropriate isolation between stainless components and dissimilar metals. If using PoE, confirm the switch or injector provides adequate power for all connected equipment. Inspect the lens, seals, bracket, and network connections regularly.

Before Ordering

Confirm MFD/NVR ONVIF compatibility, Ethernet and PoE capacity, 80° coverage suitability, preferred surface or ceiling mount, cable route, and required weatherproof RJ45 accessories before ordering.