Scanstrut Power Tower 6-Inch – for FLIR M300 Series Cameras

Description

Raise a compatible FLIR M300-series camera above roofline obstructions with the Scanstrut PowerTower 6-Inch Camera Mount. The 150 mm pedestal creates additional height for a clearer camera view over lights, rails, and other hardtop equipment while keeping the installation compact and purpose-built. Need a clean elevated base instead of fabricating a custom bracket? This PowerTower mount is designed for compatible FLIR M300 cameras and uses a marine-grade construction with a sealed base for deck, hardtop, or radar-arch installations.

Key Specifications

• Scanstrut PowerTower 6-Inch camera mount for compatible FLIR M300-series cameras.
• Approximately 6 inches (150 mm) of mounting height.
• Vertical pedestal mount for raising a compatible camera above nearby roofline equipment.
• Designed for compatible FLIR M300-series camera installations.
• Composite or marine-grade aluminum construction options, depending on the exact mount version.
• UV-resistant construction with a weather-sealed base.
• Approximate weight: 2.6 lb (1.2 kg).
• 2-year manufacturer warranty, subject to regional terms.

Compatibility

This is a mounting accessory only; it does not include a FLIR camera, joystick controller, MFD, monitor, power supply, Ethernet cable, radar, or navigation equipment. Confirm the exact FLIR M300-series camera model, mounting-hole pattern, cable-routing requirements, and required camera pan-and-tilt clearance before ordering.

Scanstrut offers dedicated FLIR M300 camera mounts in several heights, including a 150 mm PowerTower version designed for cabin roofs, flybridges, and radar arches. [892][894] The installed camera must still meet manufacturer guidance for safe viewing, radar separation, cable routing, and structural support.

Installation Notes

Mount the pedestal on a reinforced, level deck, hardtop, flybridge, or radar arch surface that can support the camera, mount, vibration, and anticipated wind load. Keep the camera’s operational field of view and pan-and-tilt path clear of antennas, radar scanners, lights, rails, rigging, and other equipment.

Use marine-grade fasteners, appropriate bedding compound, and corrosion isolation where dissimilar metals meet. Route camera cables through the pedestal or protected cable glands where applicable, use drip loops and strain relief, and inspect hardware and seals regularly after saltwater exposure.

Before Ordering

Confirm the exact FLIR M300 camera model, PowerTower mount part number, deck or hardtop reinforcement, mounting-hole pattern, cable route, total installed height, camera clearance, and required corrosion-protection hardware before ordering.